Forum Domoticz en français

Code : Tout sélectionner

For information this is the real error code error table :

0xC1 = E_ZCL_CMDS_SOFTWARE_FAILURE
0x8C = E_ZCL_CMDS_UNREPORTABLE_ATTRIBUTE

l'erreur 0xc1 peut provenir de :

Data type inconnu
Trame mal formée
buffer overflow ( trop de données dans la trame)
pas assez de données dans la trame
Plus de place dans la table des reports (limitée à 20)
// ZCL Command status (from ZCL spec)
typedef enum
{
E_ZCL_CMDS_SUCCESS =0x00,
E_ZCL_CMDS_FAILURE,
E_ZCL_CMDS_NOT_AUTHORIZED =0x7e,
E_ZCL_CMDS_RESERVED_FIELD_NOT_ZERO,
E_ZCL_CMDS_MALFORMED_COMMAND =0x80,
E_ZCL_CMDS_UNSUP_CLUSTER_COMMAND,
E_ZCL_CMDS_UNSUP_GENERAL_COMMAND,
E_ZCL_CMDS_UNSUP_MANUF_CLUSTER_COMMAND,
E_ZCL_CMDS_UNSUP_MANUF_GENERAL_COMMAND,
E_ZCL_CMDS_INVALID_FIELD,
E_ZCL_CMDS_UNSUPPORTED_ATTRIBUTE,
E_ZCL_CMDS_INVALID_VALUE,
E_ZCL_CMDS_READ_ONLY,
E_ZCL_CMDS_INSUFFICIENT_SPACE,
E_ZCL_CMDS_DUPLICATE_EXISTS,
E_ZCL_CMDS_NOT_FOUND,
E_ZCL_CMDS_UNREPORTABLE_ATTRIBUTE,
E_ZCL_CMDS_INVALID_DATA_TYPE,
E_ZCL_CMDS_INVALID_SELECTOR,
E_ZCL_CMDS_WRITE_ONLY,
E_ZCL_CMDS_INCONSISTENT_STARTUP_STATE,
E_ZCL_CMDS_DEFINED_OUT_OF_BAND,
E_ZCL_CMDS_INCONSISTENT,
E_ZCL_CMDS_ACTION_DENIED,
E_ZCL_CMDS_TIMEOUT,
E_ZCL_CMDS_HARDWARE_FAILURE =0xc0,
E_ZCL_CMDS_SOFTWARE_FAILURE,
E_ZCL_CMDS_CALIBRATION_ERROR,
E_ZCL_CMDS_UNSUPPORTED_CLUSTER,
E_ZCL_CMDS_ENUM_END
} teZCL_CommandStatus;