Page 1 sur 1
Configuration Sirène
Publié : 22 août 2016, 13:00
par Bastien
Bonjour,
j'ai installé une Sirène Fortrezz SSA2 dans Domoticz, mais je ne parviens pas à accéder aux paramètres de configuration du module. En effet, dans la partie Hardware/Node je retrouve bien mon module avec la bonne description, mais aucun élément n'apparaît sous "Configuration".
Avez-vous une idée ?
Merci d'avance !
Re: Configuration Sirène
Publié : 24 août 2016, 13:53
par Warp
Il devrait au moins apparaitre ceci ( c'est un extrait de /home/pi/domoticz/Config/fortrezz/ssa2.xml) :
Code : Tout sélectionner
<CommandClass id="112">
<Value type="byte" genre="config" instance="1" index="1" label="Delay before accept of Basic Set Off" units="seconds" min="0" max="255" value="0">
<Help>
Delay, from the time the siren-strobe turns on, before the Basic Set Off command is accepted.
This could be used, for example, to avoid the situation where an associated window/door sensor turns the SSA1 alarm on and then immediately off when the window/door is opened and then quickly closed.
-128 seconds to -1 seconds -> Interpreted as unsigned integer for negative values sent in set command.
</Help>
</Value>
</CommandClass>
Re: Configuration Sirène
Publié : 26 août 2016, 13:08
par Bastien
Merci pour ta réponse.
en fait j'ai effectivement acès au fichier xml de config qui a l'air complet, mais je ne comprends pas pourquoi du coup je n'y accède pas dans l'IHM Domoticz...une idée ?
Re: Configuration Sirène
Publié : 26 août 2016, 16:56
par Warp
Il faut peut-être l'exclure du reseau ZWave, puis le ré-inclure, car quelques fois la remonté d'informations ne se fait pas bien a l'inclusion sur le contrôleur ZWave est plus loin que 1 mètre !