Volet roulants domoticz et Ipx800 V4
Publié : 22 août 2017, 13:26
Bonjour
j'ai un script LUA qui commande un Volet roulant
je veux configurer un retour d'etat Via des push qui vient de l'ipx..
le probleme c'est lorsque je commande l'api domoticz : http://IP:8080/json.htm?type=command&pa ... svalue=Off
cela provoque une autre execution de scripte de commande donc le volet ne s'arrete jamais (loop) ..
ma question est : est ce que je peux changer la valeur du curseur ou ON/OFF du volet roulant via API sans provoqué le script de commande LUA
Merci
j'ai un script LUA qui commande un Volet roulant
Code : Tout sélectionner
commandArray = {}
val= tonumber((otherdevices_svalues['Volet Salon TV']));
val1=101-val
if (devicechanged['Volet Salon TV'])
then
--then val= tonumber((otherdevices_svalues['VR']));
str= "http://192.168.1.152/api/xdevices.json?SetVR03="..val1
commandArray['OpenURL']= str
end
if devicechanged['Volet Salon TV'] == 'On' then
str1= "http://192.168.1.152/api/xdevices.json?SetVR03=0"
commandArray['OpenURL']= str1
end
if devicechanged['Volet Salon TV'] == 'Off' then
str1= "http://192.168.1.152/api/xdevices.json?SetVR03=100"
commandArray['OpenURL']= str1
end
return commandArray
le probleme c'est lorsque je commande l'api domoticz : http://IP:8080/json.htm?type=command&pa ... svalue=Off
cela provoque une autre execution de scripte de commande donc le volet ne s'arrete jamais (loop) ..
ma question est : est ce que je peux changer la valeur du curseur ou ON/OFF du volet roulant via API sans provoqué le script de commande LUA
Merci