Upload energy data to PVoutput - script et config

[zekileeloo]

Bonjour, quelqu'un a t'il déjà utilisé et configuré ce script avec SBFSpot ?
https://www.domoticz.com/wiki/Upload_en ... o_PVoutput

Je ne vois pas comment bien remplir les paramètres du script.
Il demande:
local GenerationDeviceName = "xxxxxx" -- Device name of the Generated energy
local ImportedDeviceName = "xxxxxx" -- Name of the energy device that shows imported energy
local ExportedDeviceName = "xxxxxx" -- Name of the energy device that shows exported energy
local ConsumptionIDX = xxx -- IDX of the energy device that shows calculated Consumption
local ConsumptionDeviceName = "xxxxxx" -- Name of the energy device that shows calculated Consumption

A quoi donc cela correspond dans les devices?
Mes devices
SBFSpot 00000001 1 SolarMain General kWh 659.759 kWh
SBFSpot 00000001 1 Volt uac1 General Voltage 243.72 V
SBFSpot 00000001 1 Efficiency General Percentage 0%
SBFSpot 00000002 1 Hz General Percentage 50%
SBFSpot 00000003 1 BT_Signal General Percentage 0%
SBFSpot 0001 1 Temperature Temp