Bonsoir,
Lorsque je relance Domoticz, j'ai toujours cette ligne:
2015-06-22 19:43:53.891 OpenZWave: Invalid NodeID received. HomeID: 25483798, NodeID: 0 (0x00)
Ceci entraine, dans l'onglet "réglage" du contrôleur:
Tous les nœuds n'ont pas encore été interrogé , OpenZWave n'est pas entièrement initialisé !
Comment supprimer ce nœud invalide, Je ne retrouve rien lorsque j'édite "domoticz.db".
Cordialement
[RESOLU] Noeud invalide
[RESOLU] Noeud invalide
Dernière modification par valdoison le 24 juin 2015, 07:41, modifié 1 fois.
Domoticz sur serveur UBUNTU 18.04 - Controleur Zwave+ - 7 detecteurs FGMS 001 - 1 télécommande NODON - 1 sirene SE812 - 3 modules AN157 - 1 detecteur ST814 - 1 vanne danfoss LC13 - 1 detecteur de fumée SF812
Re: Noeud invalide
Réponse de Gizmocuz sur le site en anglais
please stop domoticz
on the raspberry:
sudo service domoticz.sh stop
then edit the openzwave configuration file, and delete node 0 (it should be at the top),
the file is located in Config/zwcfg_xxxxx.xml (xxxx is unique)
then start domoticz again
on the raspberry:
sudo service domoticz.sh start
please stop domoticz
on the raspberry:
sudo service domoticz.sh stop
then edit the openzwave configuration file, and delete node 0 (it should be at the top),
the file is located in Config/zwcfg_xxxxx.xml (xxxx is unique)
then start domoticz again
on the raspberry:
sudo service domoticz.sh start
Domoticz sur serveur UBUNTU 18.04 - Controleur Zwave+ - 7 detecteurs FGMS 001 - 1 télécommande NODON - 1 sirene SE812 - 3 modules AN157 - 1 detecteur ST814 - 1 vanne danfoss LC13 - 1 detecteur de fumée SF812